|
News Code
13685
Copied
Failure to Recognise a Suspended Load Results in Death
TIN news: The UK MAIB has issued this year Safety Digest including lessons learnt from maritime accidents. One case investigates how a failure to recognise a suspended load may result in death.
Modifications were being carried out on the diving bell recovery system of a diving support vessel. The modifications were part of an upgrade to enable the bell to be recovered in the event of a main bell winch system failure. The work involved installing a new winch arrangement for the bell's cursor.
The new winch was used to raise the 4 tonne cursor to allow technicians to work on top of the bell. The winch system was designed such that the brake was automatically applied when the winch control was placed in the neutral position or when hydraulic power was removed.
Once the cursor was in position the brake of the new winch was applied to lock it. Several technicians then worked on top of the bell for a period of time.
Part of the modification required removing buoyancy blocks from the top of the diving bell. A technician climbed on top of the bell to do this, but the blocks were very cumbersome and it became apparent that the cursor would have to be raised further to enable the blocks to be removed. Power was applied to the new winch and an operator went to a control position sited above the cursor and diving bell, from where he began to raise the cursor.
From his control position, the operator was unable to see the top of the diving bell or the technician on top of it, and was being directed by hand signals from a visible part of the deck below. Once the cursor was at a suitable height, lifting was stopped, power to the winch was switched off, and work on top of the bell set to continue. A few seconds later the winch rendered and the cursor fell, trapping the technician between the diving bell and the cursor.
Despite his colleagues' best efforts and rapid evacuation to hospital, the technician died from his injuries.
The cause of the winch failure was attributed to a faulty pilot valve in the cursor's winch control system, which prevented the winch brakes from applying once hydraulic power was removed.
Modifications were being carried out on the diving bell recovery system of a diving support vessel. The modifications were part of an upgrade to enable the bell to be recovered in the event of a main bell winch system failure. The work involved installing a new winch arrangement for the bell's cursor.
The new winch was used to raise the 4 tonne cursor to allow technicians to work on top of the bell. The winch system was designed such that the brake was automatically applied when the winch control was placed in the neutral position or when hydraulic power was removed.
Once the cursor was in position the brake of the new winch was applied to lock it. Several technicians then worked on top of the bell for a period of time.
Part of the modification required removing buoyancy blocks from the top of the diving bell. A technician climbed on top of the bell to do this, but the blocks were very cumbersome and it became apparent that the cursor would have to be raised further to enable the blocks to be removed. Power was applied to the new winch and an operator went to a control position sited above the cursor and diving bell, from where he began to raise the cursor.
From his control position, the operator was unable to see the top of the diving bell or the technician on top of it, and was being directed by hand signals from a visible part of the deck below. Once the cursor was at a suitable height, lifting was stopped, power to the winch was switched off, and work on top of the bell set to continue. A few seconds later the winch rendered and the cursor fell, trapping the technician between the diving bell and the cursor.
Despite his colleagues' best efforts and rapid evacuation to hospital, the technician died from his injuries.
The cause of the winch failure was attributed to a faulty pilot valve in the cursor's winch control system, which prevented the winch brakes from applying once hydraulic power was removed.