|
News Code
123047
Copied
Fatal electrocution accident happened onboard box ship
TIN news: A fitter on board a Hong Kong registered container ship was electrocuted when he tried to shake the chain of an electric hoist during lifting operation to lower down main engine spare part through engine room access hatch for main engine repair works prior to sailing, the Hong Kong Marine Department reports through an Information Note.
The Incident
When a Hong Kong registered container ship encountered main engine problem, she dropped anchor and waited until an engine spare part arrived by a launch. The crew used an electric hoist to lift the spare part from the launch and lower down into the engine room through an access hatch, but it was stuck in the hatch.
When a fitter tried to shake the lifting chain of the electric hoist by his hands to release the stuck of the spare part in the hatch, he suffered electric shock and lost his conscious. He was sent to a hospital at shore by a rescue launch and he was declared dead in the hospital on the same day.
Followings are the contributory factors of the accident: i. a non-marine type electric hoist having an operating voltage lower than the ship’s supply was used on board; in addition, it was not maintained properly and was not operated within operation limits recommended by the manufacturer during the lifting operation;
ii. the risk assessment and supervision of the work were not carried out properly to ensure safety of crew;
iii. electrical faults occurred in the electric hoist was due to rough handling of the equipment and there was no earth fault protection of the equipment; and
iv. the pair of cotton gloves used by the deceased was wetted by sweat causing him lectrocuted by electric current when he shook the lifting chain with his hands.
The Incident
When a Hong Kong registered container ship encountered main engine problem, she dropped anchor and waited until an engine spare part arrived by a launch. The crew used an electric hoist to lift the spare part from the launch and lower down into the engine room through an access hatch, but it was stuck in the hatch.
When a fitter tried to shake the lifting chain of the electric hoist by his hands to release the stuck of the spare part in the hatch, he suffered electric shock and lost his conscious. He was sent to a hospital at shore by a rescue launch and he was declared dead in the hospital on the same day.
Followings are the contributory factors of the accident: i. a non-marine type electric hoist having an operating voltage lower than the ship’s supply was used on board; in addition, it was not maintained properly and was not operated within operation limits recommended by the manufacturer during the lifting operation;
ii. the risk assessment and supervision of the work were not carried out properly to ensure safety of crew;
iii. electrical faults occurred in the electric hoist was due to rough handling of the equipment and there was no earth fault protection of the equipment; and
iv. the pair of cotton gloves used by the deceased was wetted by sweat causing him lectrocuted by electric current when he shook the lifting chain with his hands.